Tin and tin alloys. Ingot tin Ingestion-build-73073 Preferred sizes for thicknesses of

Preferred sizes for thicknesses of 38 mm and over are also specified

5 l water capacity and for tubes up to 3 000 l water capacity

— runout tolerance of locknut clamp face with respect to pitch diameter of screw thread

Publications mentioned in this standard

Tin and tin alloys. Ingot tin Ingestion-build-73073 Preferred sizes for thicknesses ofWhat is BS EN 610 Tin and tin alloys about? BS EN 610 is a European standard that discusses the ingot tin for tin alloys. The properties of tin make it ideal for use as a coating. Owing to the low melting point of tin, and because it readily alloys with most other metals, tin coatings can easily be produced by immersing a suitably prepared metal object in a bath of molten tin. BS EN 610 specifies the requirements for the chemical composition, surface